Protection that tackles the actual weak points
Washable finished surfaces
Marks can be cleaned from the protective face instead of soaking into decoration.
Coverage at impact height
We position protection around the beds, trolleys or carts used on your site.
Coordinated junctions
Doors, corners and handrails are planned together to avoid exposed gaps.
Stop daily traffic damaging finished walls
Beds, carts and trolleys rarely hit a wall just once. In a busy corridor or treatment space, repeated contact leaves scuffs, dents and broken corners that need repairing again and again. We install hygienic wall protection to create a washable barrier over vulnerable surfaces. Coverage can be localised around known impact points or extended across a full wall. Before fitting, we consider the equipment in use, its likely contact height and the condition of the existing surface. That gives you protection placed where it will do useful work rather than simply covering the easiest area.
Careful setting out makes protection last
A durable finish starts with preparation. We inspect the substrate, mark accurate levels and plan junctions around doors, corners, handrails and existing fittings. Sheets and protective components are then cut, fixed and finished with close attention to joints and edges. Where several products meet, we coordinate their heights and end details so the installation works as one scheme. We can also carry out remedial work when existing protection has been poorly fitted, loose or left with untidy junctions.
Frequently asked questions
How much of each wall needs to be protected?
We base coverage on room use, traffic routes and the height of equipment likely to strike the wall. Some sites need targeted sheets or rails, while repeated contact across a broad area may make wider coverage more practical.
Can you repair a poor existing installation?
Yes. We can assess loose sections, rough cuts, open junctions or protection placed at an ineffective height. The remedial work needed will depend on the product, substrate and condition of the surrounding finish.
Can wall protection be fitted around other products?
Yes. We measure around doors, handrails, corners and fixed equipment before cutting or setting out the protection. Coordinating these details helps retain access and leaves cleaner edges where different components meet.